Question:
FoxFlash Tool can’t connect to EDC16C1 ecu, pinout according to instructions on software, I tried on 3 different ones with no result. Some solutions?
Here is the
Possible Reason:
Different HW version.
Pinout on FoxFlash could work for other c1 versions but not for this one.
Solution:
1.Check connection and power supply
Pinout (K-Line):
*Watch white cable because there is also a white/red cable in package.
If error remains,
2.Try Pinout (with CAN-Line)
PIN1&7 — 12V
PIN2 — GND
PIN8 — Kline
PIN46 — CanH
PIN33 — CanL
Connect it on Bench Mode.
If error remains, remove Bench Box,
and connect to device on OBD Mode using GT100 Breakout Box + an extra power supply
Feedback:
I have a connection with the ecu!